Make sure to unplug the controller from electrical power to prevent SHOCK.
Using a standard #2 Phillips screw driver, remove the 4 cover screws, in a diagonal order.
Place cover to the side, being careful not to damage the seal lip around the rim of the enclosure.
This tutorial will use the default profile # 11 from the profile sheet. This can be downloaded in PDF format and printed from here PROFILE For profile #11, dipswitch selection is [ 001011 ] 0=OFF, 1=ON.
Using a toothpick, scribe or similar device, GENTLY set switch 1 thru 6.
Switch #1= OFF
Switch #2= OFF
Switch #3= ON
Switch #4= OFF
Switch #5= ON
Switch #6= ON
Reinstall cover, starting all screws and finally tighten in a diagonal order. Make sure all screws are snug
Plug in your BHR003 controller, after the relay test the red led will flash 11 times corresponding to the newly set thermal profile.